The Trigger Wireless Accessory Control System
One of the BEST New Products of 2017
       
 
The Trigger Wireless Accesory Control System

The Trigger Wireless Accesory Control System The Trigger Wireless Accesory Control System Main Unit The Trigger Wireless Accesory Control System Wireless Switch The Trigger Wireless Accesory Control System Wireless Switch

The Trigger Wireless Accesory Control System Conector The Trigger Wireless Accesory Control System Main Unit The Trigger Wireless Accesory Control System App

 

The Problem: Hooking up auxiliary lights, air compressor,diff lockers & other accessories to newer Trucks & Off road ATV/SUV's.

The Solution: The Trigger Wireless Accessory Control System

Trying to hook up electrical accessories on newer Trucks?
Drilling through a firewall to run wires for a switch?
Hooking up relays and running power leads away from sensor wires?
The Trigger Wireless Accessory Control System takes care of all this for you. You mount the main unit close to you power source (battery or fuse box) and hook up the power, ground and activation wires. Use the included 8' shielded harnesses to connect you accessories(up to 4 circuits). Pair the remote control switch block to the unit and your done. No dash or other panel disassembly, nor running wires all over the place and back again to get to the switches from the relays. It also eliminates the relays!
All power switching in done in the main unit including in-line fuses. The switches mounted in the truck communicate wirelessly to the main unit via RF. NO WIRES CONECT THE TWO TOGETHER so no holes to drill or wires to fish into the cab! If this wasn't "good enough" the Trigger also features Blue tooth Conductivity so your IOS or Android phone can connect to the Trigger and also control the connected accessories. In addition the app will also give you a couple extra options, strobe and dim (specifically for when lights are hooked up).

Save time & money, simplify your installs

  • 4 channel, 2 x 30 amp circuit, 2 x 10 amp circuit, All Solid State, 12-24 volt
  • Fully epoxy potted for heat dissipation and waterproofing / shock proofing
  • Bluetooth control from phone/tablet app
  • Manual buttons for on/off on top of case
  • 12 to 24 volt input, 3 wires, ground, switched positive, battery positive
  • 12 to 24 volt out with waterproof connectors
  • Fuse's built in, waterproof cover
  • LED's to indicate relay on and if fuse is blown
  • Waterproof case design
  • Waterproof connectors included
  • Controller dimensions: 5.5” x 4.5” x 2"

 

   
 
 
Trigger 2001
Wireless Accessory Control System
299.95
 

See how simple installation is:
View instructions here

   
       
       
Remember All Prices Are Canadian Funds Canadian Flag
Copyright © 2009 Softys Speed Shop. All rights reserved.